Battery Protect 100A 48V Model: BPR048100400

The Battery Protect disconnects the battery from non essential loads before it is completely discharged (which would damage the battery) or before it has insufficient power left to crank the engine.

Features

Model: BPR048100400

Maximum continuous load current: 100A

Peak current: 250A

Operating voltage range: 24-64V

Connection: M8

Weight: 0,8 Kg

Dimensions (H x W x D) mm: 62 x 123 x 120

Warranty

2 years guaranteed

Certifications

Connection Diagram

Specification

Programming made easy
The BatteryProtect can be set to engage / disengage at several different voltages. The seven segment display will indicate which setting has been chosen.

A special setting for Li-ion batteries
In this mode the Battery Protect can be controlled by the VE.Bus BMS.

Ultra-low current consumption
This is important in case of Li-ion batteries, especially after low voltage shutdown. Please see our Li-ion battery datasheet and the VE.Bus BMS manual for more information.

Over voltage protection
To prevent damage to sensitive loads due to over voltage, the load is disconnected whenever the DC voltage exceeds 64 V.

Ignition proof
No relays but MOSFET switches, and therefore no sparks.

Delayed alarm output
The alarm output is activated if the battery voltage drops below the preset disconnect level during more than 12 seconds. Starting the engine will therefore not activate the alarm. The alarm output is a short circuit proof open collector output to the negative (minus) rail, max. current 50 mA. The alarm output is typically used to activate a buzzer, LED or relay.

Delayed load disconnect and delayed reconnect
The load will be disconnected 90 seconds after the alarm has been activated. If the battery voltage increases again to the connect threshold within this time period (after the engine has been started for example), the load will not be disconnected. The load will be reconnected 30 seconds after the battery voltage has increased to more than the preset reconnect voltage.

		Downloads
Data Sheet EN [LINK]   User Manual MultiLanguage [LINK]   Declaration of Conformity IEC [LINK]   Declaration of Conformity CE [LINK]

		Assistance
For service or plant configuration call 0882 22 82 47 For technical assistance, write to [email protected]